ADSS cable, also known as all-dielectric self-supporting fiber optic cable, fiber optic cable that is used by the whole media is all-dielectric materials, self-supporting fiber optic cable itself refers to the reinforcing member can withstand the weight and external loads. This name will point to understand the environment and its key technologies of this cable: because it is self-supporting, so its mechanical strength pivotal; the use of all-dielectric material at high pressure because of cable electrical environment, you must be able to withstand strong electric influence; because it is used on overhead power tower, so there must be matching pendant fixed on the cable tower. That ADSS cable has three key technologies: cable mechanical design, suspension points and matching fittings to determine the selection and installation. ADSS - 300M-PE-36B1 ADSS fiber optic cable mechanical properties and mechanical properties is mainly reflected in the maximum allowable cable tension (Maximum Allowable Tension, referred MAT), the average annual running tension (Every Day Strength, referred EDS) and ultimate tensile strength (Ultimate Tensile Strength, referred to as UTS) and the like. ADSS - 300M-PE-36B1 high pressure, good anti-corrosion properties of electricity, lightning, can be laid at the voltage level of 500kV transmission line tower, and has a strong anti-bomb hit performance, the general gun in the sand 10 meter distance outside shooting will not cause injury to the cable fault. Also has a strong resistance to low temperature performance and environmental adaptability. Cable does not rely on power lines and independent laying, construction and maintenance are more convenient and does not require power operation, the cable is relatively cheap sometimes referred to as the daily average stress is defined as no wind, no ice, and the annual average temperature, the theoretical calculation load suffered when the cable tension, ADSS can be considered in the long run average sheets (should) force. EDS is usually (16 ~ 25)% RTS. In this tension, the fiber should be no strain, no additional attenuation, which is very stable. EDS is also the fatigue aging parameters of the cable, the cable accordingly parameter determines the anti-vibration design. UES- limit tension running tension is also known to use special means during the useful life of the cable, there may occur exceeds the maximum design loads suffered by the cable tension. Means that the cable allows short-time overload, fiber can withstand the strain within the allowable range is limited, usually UES should be> 60% RTS. Under tension, the optical fiber strain <0.5% (central tube) and <0.35% (stranding), there will be an additional fiber attenuation, but after this tension is released, the fiber should be restored to normal. This parameter ensures reliable operation within ADSS cable during the life of. ADSS cable fittings: ADSS - 300M-PE-36B1 Package: Use wood shaft closing reel, generally small size is 40 * 35 * 35cm, large size is 80 * 150 * 150cm Contact: Tel: 15366637011 QQ: 3091474508 Contact: Gejian Hao